Head tightly closing the casing pipe of the submersible pump.

Fits 110mm diameter pipe, has a hole for 40mm pipe.

Guarantee of safety for the pump

The head for closing the hole of the deep well is an element that will tightly protect the well against dirt getting into it. They can accumulate around the pump, leading to clogging or damage, and it may not be possible to pull it out due to wedge.

At the same time, the head is an element on which we can safely hang a submersible pump. Thanks to this, the pump does not hang on the line, which threatens to damage it.

Thick galvanized sheet metal was used to make the head. There is no possibility that the material will peel off under the influence of the sun or crack under the influence of frost.

Own water intake from a deep well is nowadays a great comfort.

To be able to enjoy our own water of good quality, we must properly protect the well opening against potential contamination. This is all the more necessary if the end of the casing pipe is below ground level. Then there is a considerable risk of flooding the well with rainwater with impurities. The ingress of contaminants into the deep well, in addition to quality values, carries the danger of the pump being wedged by the sand. This situation can be troublesome when dismantling the pump later. The presented closing head will minimize this risk and maintain hermetic closure even if it is completely flooded with water.

Key features:

• The head is adapted to the casing pipe with a diameter of 110 mm, has a rubber seal screwed on screws
• It is equipped with a culvert for a discharge pipe with a diameter of 40mm in the PE pipe standard
• 2 hermetic chokes were installed to route the electrical cable
• It has two screws with eyelets for suspending the pump and the head itself