CONTROLLER REGULATOR OF CIRCULATION PUMP C.O. S-150 IBO

CONTROLLER S-150 is designed to control the central heating water circulation pump. The task of the controller is to turn on the pump if the temperature exceeds the set value and the set switching temperature. This prevents unnecessary operation of the pump, which saves electricity (savings depending on the degree of furnace utilization reach up to 60%) and extends the life of the pump. As a result, its reliability increases and operating costs are reduced. Both the switching and switching temperatures can be set between 0 °C and 99 °C. Hysteresis has been replaced by the ability to freely set the off temperature.

Example; Setpoint temperature 34 °C (bottom display), cut-off temperature 31 °C. If the sensor temperature reaches 34 °C and runs until the sensor temperature drops to 31 °C, the controller switches off the pump.

The controller is equipped with 2 LED displays. The upper one displays the current temperature measured by the sensor as standard, while the lower one shows the switching temperature. The MENU button switches the controller in the preview mode and settings of the off-off, switching and setting of the anti-stop function.

THERMOSTAT FUNCTION

The controller also has a built-in thermostat function. It is possible to set the temperature at reaching, which the controller will turn off the controlled devices, and then after lowering to the desired value will start the device.

ANTIFREEZE FUNCTION

The controller is equipped with the ANTY-FREEZ function, thanks to which the controller will start the pump when the ambient temperature drops below 5°C to avoid freezing.

Technical data :

• Temperature control range -0°C-99°C
• Supply voltage - 230V/50Hz
• Power consumption - < 5W
• Operating temperature - - 10 °C - 40°C
• Temperature sensor - Resistive
• Sensor cable length - 1 m
• Network cable length - 1m
• Pump supply cable length -1m
• Output - 230V/50Hz