BUFFER ACCUMULATION BUFFER TANK 500 L DREWMET

⚡ Buffer tanks are used to accumulate excess heat from its source. The heat source can be a solid fuel boiler, heat pump, solar collectors, fireplace insert, etc.

⚡ In addition, it is possible to install an electric heater. DMS tanks are designed exclusively for heat accumulation in heating systems.

⚡ The placement of the accumulation tank in the heating system with a solid fuel boiler enables optimal operation of the boiler at the nominal operating temperature. The effect is achieved mainly during the optimal operation of the boiler (i.e. at maximum efficiency), when the excess of uncollected heat is accumulated in the tank.

⚡ These tanks are not intended for domestic hot water accumulation. These tanks are designed to operate in an upright position only.

⚡ The tank is made of steel sheet and painted with primer paint on the outside. They are designed for the use of 80mm thick insulation. Thermal insulation made of polystyrene and synthetic wool provides insulation class C.

Storage capacity: 483l

Maximum permissible temperature: 95°C

Maximum permissible pressure: 3bar

Water drain S1: GW 3/4" female thread

Connection connector GW 6/4" h1: 264mm

Connection connector GW 6/4" h2: 721mm

Connection connector GW 6/4" h3: 1181mm

Connection port GW 6/4" h4: 1634mm

Temperature sensor connector GW 1/2" h5: 249mm

Temperature sensor connector GW 3/4" h6: 414mm

Temperature sensor connector GW 3/4" h7: 964mm

Temperature sensor connector GW 3/4" h8: 1534mm

Buffer outer diameter d: 800mm

Buffer diameter without insulation: 600mm