WELCOME
TO OUR STORE
BUFFER ACCUMULATION BUFFER TANK 300L DREW-MET
Gross
zł2,841.16
Sold: 2Gross
0/5
Storage Capacity (I) 268
Max. permissible temperature (°C) 95
Max. permissible pressure (bar) 3
Buffer height (mm) 1126 h9
Buffer outer diameter (mm) 760 d
Diameter without insulation (mm) 560
Dimensions
Water drain - GW-1" h1 129mm
Connection connector - GW-6/4" h2 196mm
Temperature Sensor Connector-GW-1/2" h3 391mm
Connection connector - GW-6/4" h4 422mm
Temperature Sensor Connector-GW-1/2" h5 591mm
Connection connector - GW-6/4" h6 648mm
Temperature Sensor Connector-GW-1/2" h7 861mm
Connection connector - GW-6/4" h8 874mm
Air vent connection connector - GW-6/4" h10 1126mm
Share on:
♻️ Buffer tanks are used to accumulate excess heat from its source. The heat source can be a solid fuel boiler, heat pump, solar collectors, chimney liner, etc. In addition, it is possible to install an electric heater.
♻️ Tank type DM are designed exclusively for heat accumulation in heating systems. The placement of the accumulation tank in a heating system with a solid fuel boiler allows the boiler to operate optimally at the nominal operating temperature.
♻️ The tanks are not intended for the accumulation of DHW – domestic hot water
♻️ The DM buffer tank is designed to be operated in an upright position only.
Storage Capacity (I) 268
Max. permissible temperature (°C) 95
Max. permissible pressure (bar) 3
Buffer height (mm) 1126 h9
Buffer outer diameter (mm) 760 d
Diameter without insulation (mm) 560
Dimensions
Water drain - GW-1" h1 129mm
Connection connector - GW-6/4" h2 196mm
Temperature Sensor Connector-GW-1/2" h3 391mm
Connection connector - GW-6/4" h4 422mm
Temperature Sensor Connector-GW-1/2" h5 591mm
Connection connector - GW-6/4" h6 648mm
Temperature Sensor Connector-GW-1/2" h7 861mm
Connection connector - GW-6/4" h8 874mm
Air vent connection connector - GW-6/4" h10 1126mm
✅ The tank is made of steel sheet, the outside is painted with primer paint.
✅ They are designed for insulation with a thickness of 80 mm.
✅ The thermal insulation of the buffer tank made of polystyrene and synthetic wool ensures insulation class C.
Specyfikacja
Status | New |
---|
Comments (0)
Your review appreciation cannot be sent
Report comment
Are you sure that you want to report this comment?
Report sent
Your report has been submitted and will be considered by a moderator.
Your report cannot be sent
Write your review
Review sent
Your comment has been submitted and will be available once approved by a moderator.
Your review cannot be sent