BUFFER ACCUMULATION BUFFER TANK 800L DREW-MET

♻️ Buffer tanks are used to accumulate excess heat from its source. The heat source can be a solid fuel boiler, heat pump, solar collectors, chimney liner, etc. In addition, it is possible to install an electric heater.

♻️ Tank type DM are designed exclusively for heat accumulation in heating systems. The placement of the accumulation tank in a heating system with a solid fuel boiler allows the boiler to operate optimally at the nominal operating temperature.

♻️ The tanks are not intended for the accumulation of DHW – domestic hot water

♻️ The DM buffer tank is designed to be used in an upright position only

Storage Capacity (I) 748

Max. permissible temperature (°C) 95

Max. permissible pressure (bar) 3

Buffer height (mm) 1780 h9

Buffer outer diameter (mm) 990 d

Diameter without insulation (mm) 790

Water drain - GW-1" h1 185mm

Connection connector – GW-6/4" h2 290mm

Temperature Sensor Connector-GW-1/2" h3 630mm

Connection connector - GW-6/4" h4 665mm

Temperature Sensor Connector-GW-1/2" h5 1070mm

Connection connector - GW-6/4" h6 1045mm

Temperature Sensor Connector - GW-1/2" h7 1385mm

Connection pipe - GW-6/4" h8 1430mm

Air vent connection connector - GW-6/4" h10 1800mm