EXCHANGER STANDING BOILER WITH COIL 200L GALMET

⚡ In the Tower heat exchanger, the hydraulic connections are connected to the rear of the exchanger. This ensures convenient installation and simplifies daily use. In the rear part there is also a coupler for the sensor from the central heating boiler and a coupler for connecting the circulation pump. After the use of a circulation pump in a hot water system, it is possible to immediately draw water at a constant temperature at any point of consumption. A large, easy-to-read thermometer is placed in the front part. To ensure the stability of the tank, each Tower heat exchanger is equipped with adjustable leveling feet.

⚡ A large spiral coil located at the bottom of the tank guarantees optimal utilization of the tank capacity. Connected to any central heating boiler or fireplace, it heats as much domestic water as possible at a given time. The SGW(S) Tower heat exchanger can also be supplied by means of an electric heater installed with the GE electrical set or additional heaters installed on the flange, in the inspection opening. The use of a set of heaters on the flange provides quick access to domestic hot water, without the need to run the central heating boiler, e.g. in the summer.

⚙️ The most efficient operation of the hot water exchanger, in addition to an excellent coil, is due to proper insulation. A thick layer of hard polyurethane insulation provides increased protection and thus long water temperature retention and low operating costs.

⚙️ The guarantee of safe use of hot water exchangers is the provision of the highest quality anti-corrosion protection. The EXTRA GLASS® enamel used in GALMET heaters is a ceramic enamel applied using the "wet" method, evenly over the entire surface of the exchanger. In addition, supported by two magnesium anodes, it is a guarantee of hygienic use. Maintenance-free use is ensured by the use of active titanium anodes. Selected depending on the capacity of the tank, they do not require servicing.

Part Number: 26-208000

storage capacity: 197 l

.max. tank working pressure: 1 MPa

.max. exchanger working pressure: 1.6 MPa

.max. tank operating temperature: 95 °C

.max. heat exchanger operating temperature: 110°C

heat exchanger area: 1.4 m2

heat exchanger capacity: 9.8 l

heat exchanger power (70/10/45°C): 33.6 kW

heat exchanger capacity (70/10/45°C): 800 l/h

Magnesium Upper Anode: 5/4" 38x400 plug

magnesium bottom anode: M8 32x200 screw

h1 - cold water supply Gw 1": 210 mm

h2 - water outlet to central heating Gw 1": 290 mm

h3 - sensor cover I - tube Ø 3/8": 435 mm

crk- circulation Gw 3/4": 680 mm

h4 - hot water supply from central heating Gw 1": 790 mm

H5 - DHW outflow Gw 1": 860 mm

Heater coupler: 6/4"

L - height: 1100 mm

D - outer diameter of the tank: 670 mm